345879 (TYPE 5) - Bulkhead, Series 2a, March 1967 to October 1968

Bulkhead, Series 2a, March 1967 to October 1968

For identification purposes this version of the Series 2a bulkhead has the following features:

• Door Pillars with 5/16" Acme captive nuts.
• Door Hinges secured with 5/16" captive nuts on to nut plates.
• Ventilator Outer Panel with holes for wiper spindles and screen washer jets.
• Hinges for Ventilator Lids spot welded to the Ventilator Outer Panel.
• Quadrant type Ventilator controls.
• Parcel Shelf with holes for Round Heater Demister Tubes.
• Voltage Regulator and Fuse Box mounted direct to the Outer Ventilator Panel.
• Single wiper motor with square body fitted to LH side of glove box assembly.
• Glove Box Back Panel with trapezoid pressing to clear square wiper motor body.
• Infill pieces between Glove Box Back Panel and Door Pillars.
• Spot welded Door Check tubes.
• Has holes for Steering Unit reinforcement brackets in footwell panels.
• Small Dip Switch with wiring to the side.
• Middle Panel with holes for Round Heater and Flat Heater.
• Middle Gusset Panel with vestigial mousehole on LH side.
• Gearbox Tunnel with hole to access Clutch Bleed Nipple.
• LH Bonnet Hinge with angled bottom and mousehole.
• RH Bonnet Hinge with angled bottom and mousehole.
• Tie Rod Brackets on engine side point inwards at angles.