345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962

Shop > 1958 to 1971 - SERIES 2/2a - 88" and 109", 4-cyl. > Complete Bulkhead for Series 2/2a

345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962
  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962
  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962
  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962
  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962
  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962
  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962

  • 345879 (TYPE 3) - Bulkhead, Series 2, June 1960 to January 1962

  • Land-Rover Series 2
  • £2,600.00

:  at  £2,600.00  each

1 in stock.

Bulkhead, Series 2, May June 1960 to January 1962

For identification purposes this version of the Series 2 bulkhead has the following features:

  • Door Pillars with 5/16" Acme captive nuts.
  • Door Hinges secured with 5/16" captive nuts on to nut plates.
  • Ventilator Outer Panel with drain channel on cab side.
  • Ventilator Outer Panel has no holes for wiper spindles or washer jets.
  • Hinges for Ventilator Lids spot welded to the Ventilator Outer Panel.
  • Quadrant type Ventilator controls.
  • Parcel Shelf with holes for Round Heater Demister Tubes.
  • Holes for Voltage Regulator Mounting Plate.
  • No infill pieces between Glove Box Back Panel and Door Pillars.
  • 'Bolt on' type Door Check tubes.
  • Auxiliary panel mounted below main instrument panel.
  • Has holes for Steering Unit reinforcement brackets in footwell panels.
  • Large round Dip Switch with wiring to the side.
  • Middle Panel with holes for Round Heater.
  • Middle Gusset Panel with pilot holes for Round Junction Box.
  • Gearbox Tunnel with hole to access Clutch Bleed Nipple.
  • LH Bonnet Hinge with angled bottom and mousehole.
  • RH Bonnet Hinge with bonnet locating lug.
  • Tie Rod Brackets on engine side point inwards at angles.