345879 (TYPE 2) - Bulkhead, Series 2, January 1960 to May 1960

Bulkhead, Series 2, May January 1960 to May 1960

For identification purposes this version of the Series 2 bulkhead has the following features:

• Door Pillars with 5/16" Acme captive nuts.
• Door Hinges secured with 5/16" captive nuts on to nut plates.
• Ventilator Outer Panel with drain channel on cab side.
• Ventilator Outer Panel has no holes for wiper spindles or washer jets.
• Hinges for Ventilator Lids spot welded to the Ventilator Outer Panel.
• Screw type Ventilator controls.
• Parcel Shelf with holes for Round Heater Demister Tubes.
• Holes for Voltage Regulator Mounting Plate.
• No infill pieces between Glove Box Back Panel and Door Pillars.
• 'Bolt on' type Door Check tubes.
• Auxiliary panel mounted below main instrument panel.
• Has holes for Steering Unit reinforcement brackets in footwell panels.
• Large round Dip Switch with wiring to the side.
• Middle Panel with holes for Round Heater.
• Middle Gusset Panel with pilot holes for Round Junction Box.
• Gearbox Tunnel with hole to access Clutch Bleed Nipple.
• LH Bonnet Hinge with angled bottom and mousehole.
• RH Bonnet Hinge with bonnet locating lug.
• Tie Rod Brackets on engine side point inwards at angles.